NOTE: 1. When the machine is turned on for the first time, it will enter the cooling mode - strong gear by default.
2. The machine has the memory function, and will automatically enter the mode before the last shutdown when turning it on.
Power-on / off
Step 1: Press the "start" button to turn the machine on.
Step 2: Press the "start" button again to turn it off. Around 20 seconds later, the fan will be turned off.
Cooling mode
Step 1: Pull down to remove the front grille. And pull out the water tank, unscrew the water tank cap, and fill the water tank to the maximum water level.
Step 2: Align the water tank outlet with the notch at the bottom of the machine and insert the water tank. Then, install the front grille back.
Step 3: Press the "start" button to turn the machine on.
Step 4: Then press the "Cooling" button to adjust the fan speed. There are 4 fan speeds for your options: Low("LO") - High("HI") - Speedly("SP") - Sleep
Dry mode
Step 1: Pull down to remove the front grille. And pull out the water tank, unscrew the water tank cap, and empty the excess water in the tank.
Step 2: Align the water tank outlet with the notch above the water tank slot, push the empty water tank into the machine. Install the front grille back.
Step 3: Press the "start" button to turn the machine on.
Step 4: Then, press the "dry" button, the display panel will show the real-time humidity of the current environment. The fan speed is fixed at "LO" and could not be changed.
NOTE: The dry mode defaults to the gentle wind speed and does not support other wind speed adjustments.
Fan mode
Step 1: Press the "start" button to turn the machine on.
Step 2: Press the "Fan" button to enter it. The fan speed is "SP"(Speedly) by default. There are 3 fan speeds for your options: Low("LO") - High("HI") - Speedly("SP")
Horizontal and Vertical air swing
These 2 functions make the machine air outlet to swing within a 50° angle range.
Horizontal swing: In any mode, press the "swing left and right" button to start it.
Vertical swing: In any mode, press the "swing up and down" button to start it.
Timing / Light
Step 1: Short press the "Time/Light" button to activate the timer function in any mode.
Each press will increase the time by 10 minutes. After setting the time, wait for 3 seconds and the time on UI will flash, indicating that the time setting is successful. If you want to cancel the timing, press the timing/light button and set the time to "00min" and waiting for 3s.
NOTE: The time range is 10min - 90min.
Step 2: Long press the "Time/Light" button for 3 seconds to turn on or off the ambience light in any mode.
Child lock
Step 1: Press the "Horizontal air swing" and "Vertical air swing" buttons for about 3 seconds at the same time can lock the child lock. The child lock light is always on. Then, repeat the same procedure to switch off the child lock function.